One - How to use and maintain the mobile welding fume purifier correctly?

The current environmental protection situation is becoming more and more severe, and the application of environmental protection dust removal equipment is becoming more and more extensive, especially in factories with welding processes. In order to control welding fume, most of them are equipped with Mobile Fume Extractors and / or Industrial Dust Collectors, but during the actual operation of the equipment, due to failure to pay attention to the details of the operation, failures occurred, resulting in frequent replacement of parts.

How to use and maintain the mobile Industrial Fume Extractor correctly?

Installation of mobile Welding Fume Extractor

1. When moving or transporting the welding Mobile Fume Extractor, never tilt the machine more than 45 degrees.

2. The welding Mobile fume extractor should be installed and used on a firm and flat ground, so as to avoid noise caused by equipment vibration.

3. When installing the welding Industrial Fume Extractor , pay attention to whether the power supply voltage is consistent with the equipment, and connect the power supply correctly according to the color identification at the end of the power cord.

4. When using the Welding Fume Purifier, pay attention to step on the fixed casters of the equipment to prevent the equipment from sliding, and turn on the brakes of the casters before moving.

5. Adjust the Extraction Arms to the proper position to make it work normally. When moving, push the device body, do not push or pull the suction arm to move.

6. When installing the welding Mobile Fume Extractors, ensure that there is sufficient space around it, which should not be less than 50-100cm.

7. Check for tightness before installation. Use hand sensing or use light materials to check whether there is any air leakage at each door and suction arm of the welding fume purifier. If there is air leakage at the door, check whether the sealing rubber strip is damaged and replace it in time. If there is air leakage at the suction arm, adjust the sealing rubber ring to ensure the seal.