Dust Collector of Cutting Machine

The Dust Collector of cutting machine is manufactured by laser cutting, numerical control processing, die welding, electrostatic spraying and other processes. It has the characteristics of high cost performance and good quality. The dust remover of cutting machine adopts vertical filter cartridge structure. Under the negative pressure of the fan, the dusty gas passes through the main engine, and the smoke and dust collides with the pre filter baffle first. The large particles in the dusty gas are knocked down and the Mars is blocked. At the same time, the dusty gas can be evenly contacted with the filter cartridge after filtration and impact. When the dusty gas contacts with the filter cartridge, the dust is trapped on the outer surface of the filter cartridge, and the clean air is sent to the workshop or turbine through the filter cartridge by the fan. The filtration efficiency reaches 99.9%. The dust collector of the cutting machine adopts a decentralized filter cartridge, and the dust on the surface of the filter cartridge will automatically fall into the dust collection bucket under the action of force.
How to deal with the dust produced by plasma cutting, the dust collector of cutting machine can easily pass the environmental impact assessment.

1. When the plasma cutting machine works, it will produce a large number of cutting sparks and smoke. Generally speaking, the moving stroke of the guide rail is relatively long through the motor of the cutting head.

2. To cut off sparks, pipe type or eddy current type spark catcher must be used.

3. The dust can be filtered through the filter cartridge, and then the clean air can be discharged.

4. The movable travel guide rail is equipped with exhaust pipe and corresponding damper adjustment. When cutting at this point, the air valve corresponding to this point is opened and the dust is removed by connecting the pipe to the vacuum cleaner.

5. The national discharge standard is 20mg / m3, and the selected filter cartridge can meet the discharge requirements.

6. Use Cartridge Filter for secondary dust removal or cartridge activated carbon filter and high efficiency filter for tertiary dust removal. The dust can be controlled below 1mm and can be directly discharged indoors.

7. When the rated air volume allows, the suction of the fan increases, that is, the exhaust speed increases, the pressure head of the fan needs to be increased, and the corresponding motor power also increases. Generally, the wind speed absorption is greater than 15m / s.

8. The larger the filtration area of the filter medium, the slower the filtration speed, the better the dust collection and filtration effect, the higher the dust removal efficiency and the lower the corresponding emission concentration. Of course, this will also increase the investment cost.

9. Generally, one cutting machine is equipped with one cutting machine dust collector. Of course, several cutting machines can also be equipped with one large dust collector, which can be connected through the exhaust pipe for centralized exhaust treatment, install frequency converter and adjust the air volume.

10. The closer the cutter dust collector is installed, the shorter the exhaust duct, the straighter the wire, the fewer elbows, the smaller the air resistance and air loss, and the better the corresponding exhaust effect.

If you want to know more about it, please contact us. This is the manufacturer of cutting machine dust collector. We have many years of experience in this field.