How should the Welding Fume Exhaust System in the workshop be selected?

Large welding workshop Welding Fume Exhaust System using welding smoke treatment concentration is in the situation, put forward the new requirements of environmental protection, because big welding workshop welding station is more, the previous factory use mobile welding smoke dust removal equipment cannot to effective purify indoor welding smoke and dust, so I can only use Welding Fume Exhaust System this kind of dust removal equipment.

Industrial Dust Collectors and Mobile Fume Extractors operation mode is different, it has dust cover, pipeline, host, fan and exhaust pipes, runtime, fan of suction welding dust collected by dust cover pipeline system, repass pipe will be transported to the host to filter the welding smoke purification, After purification qualified air is finally discharged into the air through the smoke exhaust pipe.

So the air purified by the centralized welding smoke purification system is directly discharged to the outdoor high altitude, which can not only reduce the damage to the surrounding air environment, but also accelerate the diffusion of pollutants; And because the dust-containing air does not participate in indoor air circulation, it can more obviously improve the air quality in the welding room and reduce the intrusion of welding smoke to human health.
From the perspective of environmental inspection, the standard of the centralized Welding Fume Exhaust System for the welding smoke purification system is higher than the current inspection standard, which is mainly based on the design of the centralized system completely according to the actual working conditions of the workshop.

The size of the Dust Collector depends on the size of the work, to ensure that the working area can be covered. If the solder joint is scattered, a ring of anti-arc curtain can be installed around the dust collector, and a special wind shield can also be installed at the air outlet of the Industrial Dust Collectors to increase the edge air volume.

The number of filter elements placed in the main machine is determined by the welding smoke amount calculated in advance according to the number of workstations in the whole workshop. The pipeline for transporting smoke and dust will avoid driving, etc., and minimize the elbow to reduce the attenuation of air volume.

The above is the technology sharing brought by Jinan Moland Environmental Tech Co., Ltd